This is a plan for using a basic cheap components to build a very good high capacity recycler.

This plan calls for the following components.

• A 10 inch wide stream sluice.

• A sluice frame made of 1 inch PVC.

• A header box to spread out the flow of water from the pump.

• A gas or electric water pump. ( If electric needs to have a minimum of 2000GPH )

• Two plastic tubs from Wall-Mart or K-Mart.

• Two ABS 2" tank adapters, a 2" ABS angle adapter, three short pieces of 2" ABS pipe.

• Two 1/4 inch I bolts with washers and nuts.

• About 24" of 1/2 inch electrical tubing or a 1/2 inch wood dowel.

• A wire screen basket. I used a JOBE 20 mesh classifier. 

• A plastic bucket, like a 3 1/2 gallon paint bucket, for tailings.

• A pile of dirt about 8" high to set one of the tubs higher than the other.

Shipping Information